Weider Viper 2000 Uživatelský manuál

QUESTIONS?As a manufacturer, we are com-mitted to providing completecustomer satisfaction. If youhave questions, or find thatthere are missing or dama

1019. Remove the 3/8” Nylon Locknut (21), 3/8” x 1 3/4”Bolt (48), and 4 1/2” Pulley (77) from one end ofthe “I” Plates (78). Route the Long Cable (66)

This chart is provided to help you identify the small parts used in assembly. Important: Some parts mayhave been pre-assembled for shipping purposes;

1/2" x 3/8" Spacer (51)—25/16" x 2" Bolt (61)–35/16" Nylon Locknut (3)–301/4" Flat Washer (10)–105/16" Flat Washer

PART LIST—Model No. WESY60400 R0997ANote: “#” indicates a non-illustrated part. Specifications are subject to change without notice. See the back cove

979596915554939354558990924310981131001019999474947101028349328611021061849328366499695377777878218288541911812120327155948343450323150342933373010728

382885419118121203271559483434503229333730107232363913383718401423878221615338321926884241104325798024812338584454483349514783545546970555438494544519

2TABLE OF CONTENTSIMPORTANT PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

3BEFORE YOU BEGINASSEMBLED DIMENSIONS: Height: 75 1/2 in.Width: 55 3/4 in. Length: 72 in. Foot PlateLow Pulley StationHigh Pulley StationLat BarLeg Le

ASSEMBLY41288482BracketLow Side1488538311868113204127117Before beginning assembly, carefully read thefollowing information and instructions:• Place al

3. Press the 1 1/4” Inner Cap (57) into the FrontUpright (42).Attach the 1” Plastic Stop (64) to the centre holein the Stop Bracket (63) with a 5/16”

615ADJUSTMENTThe instructions below describe how each part of the weight system can be adjusted. IMPORTANT: Whenattaching the lat bar or nylon strap,

7149101179PinGrooveWelded Pin8072Upper Ends ofWeight Guideshave Holes25257267747334468674949426971844Lubricate529. Press the Weight Tube Endcap (79) i

812. Press two 1 3/4” Inner Caps (44) into each of theArms (46).Apply lubricant to the lower axles on the ArmFrame (52). Slide an Arm (46) onto one of

915. Attach the Wide Swivel Bracket (71) to the indi-cated bracket on the Top Frame (67) with a 5/16”x 3 1/4” Bolt (35) and 5/16” Nylon Locknut (3). D